Maxxim Z-Axis Issues

Written By Joren Thiessen

“Over recent months I’ve been doing an engineering investigation into the primary causes for the Z axis crashes on this specific machine. The primary cause for failure is improper shut down procedures (Machine being left on over night with air turned off). During my investigation I’ve also found several serious machine issues that need to be addressed.”

PLEASE CLICK ON THE LINK BELOW TO VIEW THE FULL DOCUMENT

Download the original pdf here : 2009-11 Shoda Maxxim Z axis issues.

Joren Thiessen
Previous

Mitsubishi PLC Backup Battery Replacement (Hitachi PLC not necessary)
Next

Motor Lubrication